Table Des Matières; General Description; Warnings - Kyocera Senco Smart BoardMaster SCN49XP Mode D'emploi

TABLE OF CONTENTS
Employer's Responsibilities ..................................................................................... 3
General Description ................................................................................................. 3
Warnings ................................................................................................................. 3
Safety Warnings ...................................................................................................... 4
Tool Use................................................................................................................... 6
Maintenance ............................................................................................................ 9
Trouble Shooting ..................................................................................................... 9
Technical Data ......................................................................................................... 9
Nail Range ............................................................................................................... 9
Noise Information .................................................................................................. 10
Declaration Of Conformity ................................................................................... 120
Limited Warranty ................................................................................................. 124
EMPLOYER'S RESPONSIBILITIES
It is the employer's responsibility to assure
this manual is read and understood by all
personnel assigned to use the tool. Keep this
manual available for future reference. Risk
assessment and implementation of appropriate controls for
all hazards are essential.
WORKPLACE HAZARDS
The following apply:
y Slips, trips and falls are major causes of workplace in-
jury. Be aware of slippery surfaces caused by use of the
tool and also of trip hazards caused by the airline hose.
y
Proceed with additional care in unfamiliar surroundings.
Hidden hazards may exist, such as electricity or other
utility lines.
y This tool is not intended for use in potentially explosive
atmospheres and is not insulated from coming into
contact with electric power.
y Make sure there are no electrical cables, gas pipes etc.
that could cause a hazard if damaged by use of the tool.
DUST AND EXHAUST HAZARDS
If the tool is used in an area where there is static dust, it may
disturb the dust and cause a hazard.
The following apply:
y
Risk assessment should include dust created by the use
of the tool and the potential for disturbing existing dust.
y
Direct the exhaust so as to minimize disturbance of dust
in a dust filled environment.
y Where dust or exhaust hazards are created, the priority
shall be to control them at the point of emission.

GENERAL DESCRIPTION

y Hand-held power fastener driving tool consisting of
a pneumatic power unit, guide body and magazine in
which energy is applied in a linear movement to a loaded
fastener for the purpose of driving the fastener into
defined materials unless using a specialized fastener
intended for use in concrete or steel.
y
Any other use is forbidden.

WARNINGS

Tools with symbol shall only be used for
production applications. Any other use is
forbidden.
y
Do not rest your finger on the trigger
when picking up the tool, moving between
operating areas and positions or walking, as
resting finger on trigger can lead to inadvert-
ent operation. For tools with selective actuation, always
check the tool before use to ascertain the correct mode
is selected.
y
This tool has either selective actuation for contact
actuation or continuous contact actuation by actuation
mode selectors or is a contact actuation or continuous
actuation contact tool and has been marked with the
symbol above. Its intended uses are for production appli-
cations such as pallets, furniture, manufactured housing,
upholstery and sheathing.
y If using this tool in selective actuation mode, always
ensure it is in the correct actuation setting.
y
Do not use this tool in contact actuation for applications
such as closing boxes or crates and fitting transportation
safety systems on trailers and lorries.
y Be careful when changing from one driving location to
another.
3
EN