Techno Line WS 6449 Mode D'emploi page 10

LCD Display:
Quick setup

Keep your weather station and wireless outdoor transmitter next to each other.

Make sure the Channel selector switch on sensor is at 1 position.

Open the battery cover at the back of your wireless outdoor transmitter and insert 2 x AAA new alkaline
batteries to the battery compartment. Replace the battery cover.

Connect the included power supply with the socket on the backside of the weather station or alternatively
you can use batteries: Open the battery cover at the back of your weather station and insert 2x AAA new
alkaline batteries to the battery compartment. Replace the battery cover. Please note, without adapter and
only batteries the backlight is always set off and you need to press the "SNOOZE/LIGHT" button to turn on
backlight for 10 seconds.

Make sure Channel 1 is displayed on the weather station. Your weather station will receive data signal
from the outdoor transmitter in a few seconds.

Place your outdoor transmitter in a dry and shaded area once the weather station receives the data of this
sensor.
Power On:

Display full segment for 2 second.

The weather station searching starts wireless sensor via 433MHz.

If the outdoor temperature is not displayed after 3 minutes, hold the "
for outdoor sensor. Then press the "TX" button on the sensor to send signal. If it still does not receive the
outdoor temperature, remove the batteries from the transmitter and go back to step 1 of the set up
Sensor Reception

Press and hold the CH/+ button for 3 seconds while viewing an empty channel to search for the sensor.

The strength signal icon will flash until the sensor signal is received or for 3 minutes if no signal available.
Adding additional sensors

Make sure Channel 2 or 3 is displayed on the weather station. Press the "CH" button to change channels
on the weather station.

Make sure the Channel selector switch on the sensor is at 2 or 3 position
" button on the main unit to search
CH
GB 2