HOW TO FOLD THE SCOOTER AGAIN
Make sure your scooter is turned off.
Open the folding lever, sliding it upwards, then turn the second protective
lever, to release the bar, then you can fold the handlebar bar on the rear fender,
where you can lock it through the clamp that carries the handlebar next to
the bell and the hook that carries the fender, this way will be protected, to
transport it, without opening.
Fold out: Open the rear mudguard hook, place the handlebar bar vertically,
lower the folding lever towards the bottom and then tighten the device holder.
After bending, hold the vertical tube with one hand or both hands to transport
it. If you notice any vibration of the handlebars, check the screws of the
folding mechanism, use the M5 hex key to lock the two screws in the folding
mechanism.
INSTRUCTIONS FOR USE THE E-SCOOTER
•
Switch on the scooter and check the battery level.
•
Place one foot on the scooter platform, the other should be behind.
EN
23