Olsson and Brothers STROOT ARROW Manuel De L'utilisateur Et Garantie page 22

EN
E-SCOOTER ASSEMBLY
•
Place the scooter on a flat surface.
•
Open the e-scooter folding lever vertically. Insert the upper bar into the
head, fitting it. This operation must be carried out with the tube in ver-
tical position.
•
Verify that the cables are connected as shown in the figure. Then tighten
the screws with an exagonal key to fix the head to the bar, making sure
they are perfectly adjusted, this step is very important for steering.
•
After the assembly, check that the display is working properly by swit-
ching on the equipment.
1.Despliegue el tubo y asegúrelo con su
doble sistema
1 Sesure the scooter standpipe
and open the parking bracket.
3.Atornille los 4 tornillos incluidos para
fijar el manillar a la barra
3 Use the hex wrench in the
packing box to lock the screws
on both sides.
Your new e-scooter must be assembled according to the previous steps, as
shown in the figure. Make sure that you have completed all the steps during
assembly.
22
2.Instale el manillar en la barra,
asegurese que los cables están por
2 IInstall the crossbar and
dentro
standpipe.
4. Pulse el boton de encencido durante
unos segundos, debajo del manillas
4 After the completlon of the
installation to carry out switch
detection.