Cub Cadet CC 3024H Manuel page 13

How To Apply Chemicals/Cleaning Solvents
Applying chemicals or cleaning solvents is a low
pressure operation.
NOTE: Use only soaps and chemicals designed for pressure
washer use. Do not use bleach.
To Apply Chemicals:
1. Ensure detergent siphon hose is attached to barbed fitting
location near high pressure hose connection of pump
as shown. See Figure 4-3.
2. Place other end of detergent siphon hose with filter on it
into container holding chemical/cleaning solution.
NOTE: For every 7 gallons of water pumped 1 gallon of
chemical/cleaning solution will be used.
3. Install low pressure (black) nozzle into quick connect fitting
of spray wand, see "How To Use Spray Wand" paragraph in
this section.
4. After use of chemicals, place detergent siphon hose into
container of clean water and draw clean water through
chemical injection system to rinse system thoroughly.
If chemicals remain in the pump, it could be damaged.
Pumps damaged due to chemical residue will not be
covered under warranty.
NOTE: Chemicals and soaps will not siphon if the black soap
nozzle is not installed on the spray wand.
Figure 4-3
How To Apply Chemicals/Cleaning Solvents
(if equipped with Detergent Tank)
Applying chemicals or cleaning solvents is a low pressure
operation.
NOTE: Use only soaps and chemicals designed for pressure
washer use. Do not use bleach.
To Apply Chemicals:
1. Remove the cap from the detergent tank and fill the
detergent tank with cleaning solvent. Replace cap on
deteregent tank. See Figure 4-4.
NOTE: For every 7 gallons of water pumped 1 gallon of
chemical/cleaning solution will be used.
Figure 4-4
2. Install low pressure (black) nozzle into quick connect fitting
of spray wand, see "How To Use Spray Wand" paragraph in
this section.
NOTE: Chemicals and soaps will not siphon if the black
soap nozzle is not installed on the spray wand.
3. After use of chemicals, the detergent tank with clean water
and draw the clean water through chemical injection
system to rinse system thoroughly. If chemicals remain in
the pump, it could be damaged. Pumps damaged due to
chemical residue will not be covered under warranty.
S
ection
4 — c F
ontrolS and eatureS
13