Publicité
Les langues disponibles
Les langues disponibles
Inputs
Gain
5
0
-9
Mute
Clip
0
10
Passive
Active
MODEL TYPE: YS1071
A-Z1033R /1v0
DESIGNED & MANUFACTURED BY
YORKVILLE SOUND • TORONTO, CANADA
DynaBass 300 Bass Guitar Amplifier
DynaBass 300/300T
Thank you for choosing the DynaBass 300. You will discover that this bass amplifier has
the ability to sound "right" with a minimum amount of knob twirling and delivers great tone
making it perfect for your any performance. Best of all its lightweight, compact design will
make setups/teardowns a great deal easier.
When you need the extras, they're all here:
• Dual Inputs are provided for standard Passive pickups (0 dB) and extra-hot or
Active pickups (-9 dB).
• An input Clip LED illuminates if the input signal is set too high on your bass.
• Gain and Master controls let you dial-in the perfect amount of clarity, warmth or even
overdrive at the right level.
• The Scoop control lets you tailor your sound precisely and uniquely by emphasizing
lows and highs while reducing the midrange.
• Active Bass, Low-Mid, Hi-Mid and Treble tone controls provide up to 15dB of
cut or boost
• A separate selectable Limiter helps prevent output-stage clipping distortion when
clarity is what you seek.
• A separate Tuner Out jack lets you keep your tuner connected without affecting your signal
quality. This also makes tuning convenient since it's always available for quick reference and
adjustments. Using the Mute button ensures that the audience doesn't hear you tuning.
• The balanced XLR Line Out is selectable via front-panel pushbutton between Pre-EQ
(dry) or Post-EQ (wet).
• A Speakon™ and two ¼-inch Speaker Outputs are provided for your convenience. All
jacks are in parallel and the overall minimum load is 4 ohms.
• The Phones jack permits connecting headphones for silent practicing, or monitoring
yourself in the studio
• A unique Monitor In jack and Monitor Gain control on the back panel allow you to mix
in a main or monitor line feed from the mixer. The line feed sent through the Monitor In
jack does not get sent to the Line Output (DynaBass 300 and 300T Combos only)
• Balanced ¼-inch Efx Send and Return jacks
• A full-range speaker system with acoustically matched and precisely crossed-over low
and high-frequency drivers (DynaBass 300 and 300T Combos only)
• A Tweeter Defeat/Active switch on the back of the cabinet allows you to pre-set the
DynaBass 300 for higher note definition or a softer vintage sound (DynaBass 300 and
300T Combos only)
Please take a little time to read the following instructions; then plug in, switch on, and unleash
your musical creativity!
Bass
Low-Mid
Hi-Mid
Treble
0
0
0
0
-15
+15
-15
+15 -15
+15 -15
+15
DynaBass
1
DynaBass
300
Scoop
MASTER
5
5
4
6
Post-EQ
3
7
Pre-EQ
2
8
1
9
Line
0
10
0
10
Out
Tuner
Limiter
400 Hz
In
Out
SPEAKON™
Pin Config
0
10
Monitor
Monitor
300
Send
Gain
In
EFX
Power
Phones
On
1+1–
SPEAKER OUTS
Min 4 ohms
Lift
GND
Rtn
Line Out
Publicité
