Table des Matières
Publicité
FIG. 2
13. Fit the nuts with fixing hooks suppliedinside the top and bottom sections of the flues at the rectangular slots. A total of 14 nuts must be fitted.
14. Join the two top sections of the flue to cover the truss so that one of the slots on the sections is on the same side as the control panel and the other is on
the opposite side.
Screw the two sections with 8 screws (4 each side - see the plan diagram for joining the two sections).
15. Fix the top flue assembly to the truss, near the ceiling, with two screws (one each side).
FIG. 3
16. Join the two bottom sections of the flue covering the truss using 6 screws (3 each side - also see the plan diagram for joining the two sections).
17. Insert the bottom section of the flue in its seat so that it completely covers the motor compartment and electrical connection box, then secure it from inside
the hood using two screws.
18. Apply the 2 tabs (supplied) to cover the fixing points of the bottom flue sections
(IMPORTANT! THE TABS FOR THE BOTTOM FLUE ARE THE NARROWER AND LESS DEEP ONES).
The wider and deeper tabs are those used for the top flue, and must be cut to size.
Turn the mains power on again at the central electrical panel and check for correct hood operation.
GB6
Publicité
Table des Matières
