Table des Matières
Publicité
INSTALLATION - ASSEMBLY INSTRUCTIONS
Do not connect the hood to the electrical power supply until installation is completed.
WARNING:
Note: Parts marked with the symbol "(*)" are optional accessories supplied only with some models or parts not supplied, to be purchased separately.
Before beginning installation, decide which version of the hood you wish to use:
Extractor Version: fumes are extracted and expelled to the outside through an exhaust duct fixed to the collar (B) at the top of the hood.
WARNING:
Filter Version: air is filtered through two carbon filters and recycled into the surrounding environment.
WARNING:
Expansion plugs are provided to secure the hood to most types of ceilings. However, a qualified technician is needed to make sure that
the plugs are suitable for your ceiling. The wall/ceiling must be strong enough to take the weight of the hood.
Disconnect the power supply at the home main switch during electrical connections.
FIG. 1
1. Adjust the extension of the hood support structure, as the final height of the hood depends on this.
Note: In some cases the top section of the truss is fixed to the bottom section with 1 or more screws. Check for and temporarily remove any screws to
enable adjustment of the support structure.
2. Fix the two sections of the structure using 16 screws (4 each corner).
For extension beyond the minimum height, fit 1 or 2 brackets (depending on how many are supplied) to the top section to reinforce it.
Note: for transport purposes, 1 bracket may be temporarily fixed to the truss already with 2 screws; if so, move it to the desired position and complete the
fixing with a further 6 screws.
To fit the brackets, proceed as follows:
a. Open the brackets slightly in order to fix them to the outside of the structure.
b. Position the reinforcement bracket directly above the point where the two sections of the hood are joined and secure with 8 screws (2 each corner).
If supplied, fix the second reinforcement bracket so that it is equidistant from the first reinforcement bracket and the top edge of the truss, secure with 8
screws (2 each corner).
Note: when positioning the reinforcement bracket/s, make sure they do not hinder fixture of the exhaust pipe (extractor version) or the deflector (filter
version).
3. Hook the hood to the truss, check for perfect hooking - to hook the hood to the truss tighten the 16 screws (4 each corner).
4. Place the ceiling hole diagram directly above the cooktop (the centre of the diagram must match the centre of the cooktop and the edges must be parallel
to the sides of the cooktop - the side of the diagram with the wording FRONT corresponds to the control panel side). Prepare the electrical connection.
5. Drill as shown (6 holes for 6 wall plugs - 4 plugs for hooking), screw the 4 outer screws leaving a space of about 1 cm between the screw head and the
ceiling.
6. Hook the truss on the ceiling to the 4 screws (see step 4).
7. Tighten the 4 screws.
8. Insert and tighten another 2 screws in the remaining free holes for secure fixing.
9. Fit the 2 nuts with fixing hooks to the truss at the rectangular slots.
10. Fit an exhaust duct inside the truss and connect it to the collar of the motor compartment (exhaust pipe and clamps are not provided). The exhaust duct
must be long enough to vent externally (Extractor version) or reach the deflector F (Filter version).
11. For Filter Version only: fit the deflector F sul on the truss and fix it to the bracket with 4 screws, then connect the exhuast duct to the collar on the deflector.
12. Carry out the electrical connection to the mains power supply, only turn on the power supply with assembly completed.
The exhaust pipe and clamps are not supplied and must be bought separately.
If the hood is has a carbon filter fitted, the filter must be removed.
If the hood is not equipped with carbon filters, they must be ordered and fitted before use.
GB5
Publicité
Table des Matières
