Publicité
Les langues disponibles
Les langues disponibles
Switch Installation
1. Drill (2) 5/32" (4mm) holes 9/16" (14mm) apart for the switch mounting panel (item
#4). The slots at the top or bottom of the mounting panel can also be used as a guide.
2. Install the mounting panel using (2) #10 self-tapping screws (item #2f) through the
slots of the panel.
Snap the switch (item #5) into the mounting panel after the switch wires are plugged
into it.
Wiring Installation
D
O NOT CONNECT NEGATIVE BATTERY CABLE OR ENGAGE CLUTCH UNTIL INSTALLATION IS COM
.
PLETE
M
AKE SURE WIRES ARE NOT DRAWN TAUT ACROSS ANY SURFACES THAT COULD DAMAGE THEM
T
IGHTEN NUTS ON LARGE SOLENOID TERMINAL STUDS TO
D
O NOT OVERTIGHTEN
Rocker switch
in OFF position
SWITCH
BATTERY
RED (#1e)
.
BLACK (#1c)
RED (#1b)
YELLOW (#1a)
SOLENOID
35-40
-
IN
5 amp
FUSE
BLACK (#1d)
2
. (3-4 N
)
LBS
M
TORQUE
GROUND
WIRE SPLICE
TO VEHICLE
IGNITION
RED (TO WINCH
POWER)
BLACK (FROM
WINCH GROUND)
-
.
.
Publicité
