Bahco BCL31D1 Manuel page 7

5. SPECIFIC SAFETY RULES AND/OR SYMBOLS
Recycle
....................
Class II Tool
....................
Do not incinerate and put the battery
on fire
..................
Do not wet
....................
Alternating Current
a.c.
.................
Watts
W
.......................
Hz Hertz
....................
kg Kilograms
....................
kg-cm Kilograms - Centimeter
......
6. FEATURE
1
2
3
4
7. OPERATING INSTRUCTIONS
Removing or Installing Battery Pack
1. Always switch off the machine before insertion or removal of the
2. To remove the battery pack, push the button on the battery pack and
3. To insert the battery pack, align the tool unit slides with the battery
4. Do not force the battery pack in sliding it into tool unit. If the battery
Charging the Battery Pack
1. Plug the fast charger into the power source.
2. Slide the battery pack into the charger as the arrow direction shown on the charger.
3. Push the battery pack into place and make sure the red light on the charger is "ON". The
battery pack is now starting the charging cycle.
4. A fter finish the charging cycle, the light will turn into green. The battery pack is now ready
for use.
d.c.
V
/min
mm
ft-lb
battery pack.
pull the tool unit from the battery pack in the direction.
pack sliding groove and push the tool unit into place.
The tool unit can be slide into battery pack in two directions.
pack does not slide in easily, it is not being inserted correctly.
• 7
Do not throw in Garbage
....................
Indoor use only
..................
Do not recharge if the battery is broken
or damaged
....................
Risk of electric shock
................
Direct Current
...............
Volts
........................
Revolutions or Reciprocations per Minute
............
Millimeter
..............
Foot-Pound
..............
5
6
7
1. Torque Adjustment Ring
2. Chuck
3. LED
4. Main Switch
5. High/Low Speed Rod
6. Side Panel
7. Forward/Reverse Rod
•