Bahco BCL31D1 Manuel page 5

2. PRODUCT SAFETY INSTRUCTIONS
WARNING
1. To ensure the designed operational integrity of power tools, do not remove
installed cover or screws.
2. Use your tool at lower input than specified on the nameplate, otherwise, the
finish may be spoiled and working efficiency reduced by motor overload.
3. Do not wipe plastic parts with solvent. Solvents such as gasoline, thinner,
benzene, carbon tetrachloride, alcohol, ammonia and oil containing chloric
annex may damage and crack plastic parts. Do not wipe them with such
solvent. Wipe plastic parts with a soft cloth lightly dampened with soap water.
4. Use clamps or other practical way to secure and support the work piece to a
stable platform. Holding the work by hand or against your body is unstable
and may lead to a loss of control.
5. Use only accessories that are recommended by the manufacturer for your
model. Accessories that may be suitable for one tool may create a risk of
injury when used on another tool.
3. IMPORTANT SAFETY INSTRUCTIONS FOR CHARGER & BATTERY PACK
WARNING
1. Caution: To reduce risk of injury, charge only specific type rechargeable
battery packs. Other types of battery packs may burst causing personal injury
and damage.
2. Before using charger, read all instructions and cautionary markings on battery
packs and chargers.
3. Do not expose charger to rain or snow.
4. To reduce the risk of damage to electric plug and cord, pull by plug rather than
cord when disconnecting charger.
5. Use of an attachment not recommended or sold by the charger manufacture
may result in a risk of fire, electric shock, or injury to persons.
6. Make sure cord is located so that it will not be stepped on, tripped on, tripped
over, or otherwise subjected damage or stress.
7. Do not operate charger with damaged cord or plug. Replace them
immediately.
8. Do not operate charger if it has received a sharp blow, been dropped, or
otherwise damage in any way, take it to qualified center.
9. To reduce risk of electric shock, unplug charger from outlet before attempting
any maintenance or cleaning. Turning off controls will not reduce this risk.
10. Do not disassemble charger or battery pack, take it to a qualified service
center while repair is required. Incorrect reassembling may result in a risk of
electric shock or fire.
• 5 •