Publicité
Les langues disponibles
Les langues disponibles
Getting started.
PLEASE KEEP
THESE IMPORTANT
SAFEGUARDS IN
MIND WHEN USING
THE APPLIANCE:
•
Make sure the base is plugged in
for use.
DO NOT
•
attempt to operate the pitcher
on the appliance without attaching
the pitcher lid and vented lid cap.
• Never run the appliance while empty.
• Appliance accessories are not
intended to be used in the microwave
as it may damage the accessories.
•
Never
leave the appliance
unattended while in use.
Never blend hot liquids
when using any sealed
NutriBullet
cups.
®
Heated ingredients can pressurize
sealed containers when agitated
and violently expel hot contents upon
opening. Always start the blending
process with room temperature or
refrigerated ingredients and liquids
(21°C/70°F or cooler).
14
Use extra caution when
blending hot liquids in the
pitcher.
Steam and splatters can escape
through the vented lid, potentially
causing scalding and/or burns.
NEVER
blend hot liquids in your
pitcher without the pitcher lid
and vented lid cap attached. The
vented lid cap is ventilated to allow
steam and pressure to release,
while guarding against excess
NEVER blend hot liquids
splashing.
in your Nutribullet cups or any
other sealed vessel.
When blending hot liquids, add
liquid and solid ingredients to your
pitcher below their respective MAX
lines. Attach the pitcher lid with the
vented lid cap inserted. Press the
POWER
icon, then begin blending on
LOW
the
setting. Once ingredients
are integrated and the mixture is
level (no splashing), increase speed
as needed.
Pitcher assembly
& use.
1
Review all warning and
caution statements in the
Important Safeguards
section (pg 3-9) and on
the previous page before
proceeding to Step 2.
2
Place the motor base on
a clean, dry, level surface
such as a counter or table.
3
Place the pitcher on a
clean, dry, level surface.
Add the ingredients to the
pitcher, making sure they do
not exceed the MAX
line.
NOTE:
The blending pitcher is
marked with two MAX lines:
one for solid ingredients
(higher line) and one for
liquids (lower line). When filling
the blender, make sure your
ingredients do not exceed their
respective MAX lines.
4
Place the pitcher lid with
vented lid cap attached on
the pitcher, making sure it's
aligned to the
handle.
5
Place the pitcher onto the
motor base — handle facing
to the right of the blending
control panel, never towards
the back — and gently twist
clockwise so it locks in
place.
When you hear the click, it's
locked and ready to blend.
NOTE:
If you are left-handed, place
the handle facing towards the center
of the blending control panel and
twist clockwise.
15
Publicité
