Introduction; Caution; Warning; Information - Efiamma Aqva 10 Manuel D'utilisation Et D'entretien

Introduction

Caution

It is recommended to carefully read this manual describing all the necessary operations to properly operate the thermo-stove.

Warning:

The installation and operation rules contained in this manual may differ from the local regulations. In this case, always follow the local
competent authorities' directions. The drawings contained in this manual are indicative and not in scale.

Information:

The packaging used offers good protection against damage as a result of transport. In any case, check your thermo-stove immediately
after delivery and, in case of any visual damage, immediately inform your Efiamma reseller.

Use and maintenance manual description:

Through this use and maintenance manual, Efiamma is supplying the user with all information necessary to safely use the thermo-
stove and thus avoid any damage to property, people, or parts of the thermo-stove itself.
p
leaSe carefully read thiS manual before uSing the product and performing any operation on it

Warnings

The Efiamma stoves are manufactured paying careful attention to each individual component, in order to protect both the user and the
installer from the danger related to possible accidents. It is recommended for authorised personnel to pay careful attention to electrical
connections after each intervention on the product.
Installation must be completed by authorised personnel, who must give the purchaser a system conformity declaration, taking
full responsibility for the final installation and resulting proper operation of the product installed. Both during installation and
use, all national, regional, provincial and municipal laws and regulations in force in the Country where the equipment is installed
must be taken into account. There shall be no liability on the part of if these precautions are not followed.
This manual is an integral part of the product: make sure that it is always supplied with the thermo-stove, even if it is sold to a different
owner or user, or transferred to a different place. Should the manual be damaged or lost, request a copy from technical service. This
thermo-stove must be destined to the use it was specifically designed for. The appliance must not be used as an incinerator or differently
from its purpose. Any contractual and non-contractual liability of the manufacturer is excluded for damages to persons, animals or property
due to installation and maintenance adjustment errors and improper use. No fuel outside of pellet must be used. Do not use liquid fuels.
After removing the packaging, ensure integrity and completeness of the content. All of the thermo-stove electrical components must be
exclusively replaced by an authorised Technical Support Centre using original parts. The thermo-stove must be serviced at least once
a year, and maintenance work scheduled ahead of time with the technical support service. Do not make any unauthorised changes
to the appliance.
For safety reasons, it is important to remember that:
-
The appliance is not intended to be used by people (including children) with reduced physical, sensory or mental capacity or by
people with no experience or knowledge, unless they are supervised or properly instructed by a person responsible for their safety.
Children should be supervised to ensure they do not play with the appliance
-
Touching the thermo-stove with bare feet and wet parts of the body is not recommended;
-
Modifying safety or adjustment devices without authorisation or instructions on the part of Aico S.p.A. is prohibited
-
Installing the equipment in small rooms, bedrooms, potentially explosive environments, etc. is prohibited
-
Pouring pellet directly into the brazier before switch-on is prohibited;
-
before connecting the equipment, make sure that the water mains pressure does not exceed 2 bar;
-
The equipment works exclusively with wood pellets, so do not fuel the thermo-stove with a different fuel.
-
During the first ignition it is normal for the product to emit smoke / bad odour due to thermal stabilisation of the paints.
Keep the installation area well ventilated for a few days or until the odour is gone.
The installer shall inform the user that:
1. In the case of water spills, water supply must be closed and the technical service promptly alerted.
2. The system operating pressure must be periodically checked. If the thermo-stove is not used for a long
advisable to contact technical support to perform the following operations:
-
Close the taps of both the thermal and sanitary systems;
-
Empty the thermal and sanitary systems if there is a risk of frost.
When the thermo-stove is running, it may reach high touch temperatures, especially on its external surfaces: pay attention in order to avoid
burns.
The thermo-stove was designed to operate under any climactic condition. In case of particularly harsh conditions (wind, frost),
safety systems stopping the thermo-stove operation may be triggered.
If that should occur, contact technical after-sales service and, in any case, do not disable safety systems.
a -
ll of our Thermo sToves are TesTed
15 20 . T
from To minuTes races of pelleT
chamber are normal and indicaTe ThaT The machine has passed all qualiTaTive and operaTional TesT aT The end of The producTion
. TheY do noT indicaTe ThaT The sTove is used
line
.
producTion process
Model Aqva 10 Use and Maintenance Manual
( )
Turned on a The end of The producTion line for a variable amounT of Time ThaT goes
, ,
pelleT dusT ashes and
buT TheY show The added qualiTY ThaT
/
or signs of combusTion in The brazier and in The combusTion
Rev.0 04/03/2019
Page49
EN
.
period of time, it is
e
fiamma applies To The