Publicité
Les langues disponibles
Les langues disponibles
G B
G B
When the crossed-out wheelie bin symbol is attached to a product, it means that the product is covered by European
Directive 2002/96/EC.
Your product is designed and manufactured using high-quality materials and components which can be recycled and used
again.
•
Please take time to enquire about your local electrical and electronic waste sorting system.
•
Please respect local regulations and do not dispose of your used products with everyday household waste.
•
If you dispose of your used product in the correct way, you will help to prevent any potential adverse
effects against the environment and human health.
This appliance should not be used by anyone (including children) with reduced psychic, sensory or mental capacities or
by anyone who does not have experience and knowledge of this type of appliance, unless they are under the control and
guidance of those responsible for their safety. Special care should be taken to make sure that children do not play with
The appliance should be assembled and connected by a qualified fitter*.
•
•
Use the pegs adapted to the support structure; consult manufacturers for details; seal if necessary. The company does
not accept responsibility for any attachment fault due to drilling and pegging.
•
The separate motor (3) must be installed indoors.
•
Observe the outlet diameter of the appliance.
GB
•
Do not reduce the sections of pipes evacuations.(1) (4)
•
Avoid kinking in the facilities of exhaust ducts, optimize lengths.
Guide the airflow
•
•
The length of evacuation duct located between the separate motor to the outer discharge outlet must be less than or
equal to the length of discharge pipe located between the hood (sensor) and the input of the separate motor.
•
To attach the hoses and / or leads on the inputs and outputs of the appliance (5), use clamps or tape the aluminum
coating.
•
The maximum vacuum created in the room should be a lower 0.04mbar, which prevents combustion gas back.
•
The appliance must be positioned so that the power plug is accessible.
•
If the separate motor and ducts evacuations are installed in a particularly cold room, use thermal insulation.
•
It is preferable that the separate motor output is directed upwards forming a vertical axis with the input of the
•
Placing the check valve (2) at the output of the separate motor and before the discharge duct that leads to the external
output.
THIS EQUIPMENT COMPLIES WITH THE FOLLOWING REGULATIONS:
2006/95/EC on electrical safety, 2004/108/EC on electromagnetic compat-
ibility, 93/98 on marking, 65/2014 on energy labelling 2010/30/EU 66/2014
on ecodesign 2009/125/EC, IEC 60704-2-13, IEC 0335-2-31 Article 7 IEC
60335-1 Article 7-1
ASSEMBLY RECOMMENDATION
*any failure to meet this condition invalidates the manufacturer's warranty and any action in the event of an accident.
the appliance.
Publicité
