Sunny SF-B1879 Mode D'emploi page 17

ADJUSTMENTS AND USAGE GUIDE
2
70 #103
40
B
A
22
7
23
ADJUSTING THE HEIGHT AND BALANCE
In order to achieve a smooth and comfortable ride, you must
ensure that the stability of the bike is secured. If you notice that
the bike is unbalanced during use, adjust the Adjustment Foot
Pads (No. 40) located beneath the Front & Rear Stabilizers
(No. 2 & No. 3) of the bike. To do so, use Spanner (No. 103) to
loosen Hex Nut (No. 70) by turning it clockwise (direction A).
With the nut loosened, rotate the Adjustment Foot Pad (No. 40)
until it sits level with the surface that the bike is on. When you
3
have finished adjusting the Adjustment Foot Pad (No. 40), re-
tighten the Hex Nut (No. 70) by turning it counter-clockwise
(direction B) to complete the balance adjustment of the bike. If
needed, repeat this process to adjust the remaining Adjustment
S13
Foot Pads (No. 40).
ADJUSTING THE RESISTANCE
Adjust the resistance of the bike using the Tension Control
Knob (No. 22). Increase the level of resistance by turning the
Tension Control Knob (No. 22) to the RIGHT (clockwise),
decrease the level of resistance by turning the Tension Control
Knob (No. 22) to the LEFT (counter-clockwise).
EMERGENCY BRAKE
During use, users can stop the bike completely by pushing down
on the Tension Control Knob (No. 22). Pushing down on the
Tension Control Knob (No. 22) will enforce the brake and bring
the bike to an immediate stop.
ADJUSTING THE SEAT
The seat of this bike is fully adjustable as it moves Up, Down,
Fore (forward), Aft (backward).
To adjust the height of Seat Post (No. 7), loosen and pull the
8
Adjustment Knob (No. 23) outward, then raise or lower the
23
Seat Post (No. 7) to the desired height. Once adjusted, re-insert
and tighten the Adjustment Knob (No. 23) to secure the Seat
Post (No. 7) in place.
To adjust the seat back and forth, loosen and pull the
Adjustment Knob (No. 23) outward, then slide the Seat Slider
(No. 8) to desired position. Once positioned, re-insert and tighten
the Adjustment Knob (No. 23) to secure the Seat Slider (No.
8) in place.
16