4.
Looking down into the interior of the Blending Chamber, you will
see two stainless steel screws. This is where the clips attached to
the Plastic Collar lock the grinding mechanism down.
5.
When putting the Plastic Collar into position, align
the Tabs with the indents in the base of the Blending
Chamber. With firm but gentle pressure, press the
Plastic Collar down until the Clips "click" into place.
6.
Once everything is in place, make sure the Clips are
pushed inward toward the screws to lock the unit into
position and lift slightly to ensure the Grinding Cage
is locked into position properly and will not release.
Lock and unlock Clips carefully to avoid breaking.
NOTE: IF THE PLASTIC COLLAR IS NOT LOCKED PROPERLY
THE UNIT WILL GRIND BUT WILL NOT DISPENSE.
Now you are ready to enjoy cold, refreshing margaritas and
drinks from your STAINLESS STEEL MARGARATOR!
HOW TO OPERATE
1.
Before first use, remove all packaging materials and detach Blending Chamber from
Base by sliding the three UNLOCK/LOCK switches to the UNLOCK position.
2.
Pour warm, soapy water into the Blending Chamber and
dispense all of the soapy water through the Spout.
3.
After dispensing all warm, soapy water, rinse by pouring clean water
into the Blending Chamber and dispense clean water through the Spout
until no soapy residue remains and water comes out clean.
4.
Wipe down the STAINLESS STEEL MARGARATOR exterior with a clean, non-
abrasive cloth or sponge. Dry interior and exterior thoroughly with dry,
non-abrasive cloth or sponge. DO NOT put the Base in water.
5.
After drying, firmly attach Blending Chamber to Base by placing the
Blending Chamber on top of the Base so that Spout faces forward and
slide the three LOCK/UNLOCK switches to the LOCK position.
6.
If Blending Chamber is attached properly, it will be aligned
with Base so that the Spout is over the Drip Tray.
7.
Find a stable surface near an electrical outlet before starting. Make sure the cord is
away from any water source. It is acceptable to use an extension cord if needed.
8.
DO NOT place the STAINLESS STEEL MARGARATOR near the edge of a table or countertop.
9.
Fill the Blending Chamber with ice and ingredients to
the Max Fill line. DO NOT exceed the Max Fill line.
10. To make a batch of margaritas, fill Blending Chamber
with ice up to the Max Fill line and then pour three
parts concentrated mix (approximately 45 oz.) to 1 part
Tequila (approximately 15 oz.). For a slushier mix, less
liquid or more ice is recommended. It is NOT recommended that you use fruit.
Plastic Collar
Clips
Tabs
6