MSI X299 GAMING PRO CARBON Présentation Rapide page 59

fEnhanced Turbo [Auto]*
Enables or disables Enhanced Turbo function for all CPU cores to boost CPU
performance. This item appears when the installed CPU supports this function.
[Auto] This setting will be configured automatically by BIOS.
[Enabled] All CPU cores would be increased to maximum turbo ratio.
[Disabled] Disables this function.
f CPU Base Clock (MHz)
Sets the CPU Base clock. You may overclock the CPU by adjusting this value. Please
note that overclocking behavior and stability is not guaranteed. This item appears
when a CPU that support this function is installed.
f CPU Base Clock Apply Mode [Auto]*
Sets the applying mode for adjusted CPU base clock.
[Auto] This setting will be configured automatically by BIOS.
[Next Boot] CPU will run the adjusted CPU base clock at next boot.
[Immediate] CPU runs the adjusted CPU base clock immediately.
f Clockgen Features
Press Enter to enter the sub-menu. Sets the detailed clockgen features.
fDynamic Frequency Control [Disabled]
Enables or disables to try different CPU BCLK under CPU loading to overclock the
system. This item will be disabled when the Dynamic Frequency Search is enabled.
fDFC Baseline (MHz) [Auto]
Sets initial BCLK for dynamic overclocking if not reach the threshold. This item will
be available when the Dynamic Frequency Control is enabled.
fThreshold 1~3 (A) [Auto]
Sets the CPU current as the threshold for Dynamic Frequency Control. When
CPU current reaches the value, it will run the Level 1/ 2/ 3 BCLK for dynamic
overclocking. These items will appear when the Dynamic Frequency Control is
enabled.
fLevel 1~3 BCLK (MHz) [Auto]
Sets the CPU BCLK for the threshold. These items will appear when the Dynamic
Frequency Control is enabled.
fDynamic Frequency Search [Disabled]
Enables or disables to run the optimized dynamic BCLK. This item will be disabled
when the Dynamic Frequency Control is enabled.
fDynamic Frequency Search Mode [Once]
Sets the search mode of the dynamic BCLK. This item will be available when the
Dynamic Frequency Search is enabled.
[Once]
[Each Power On] Run in every time when system is powered on.
fDynamic Frequency Search Step (MHz) [Auto]
Sets the increase for running the dynamic BCLK. If set to Auto, BIOS will configure
this setting automatically. This item will be available when the Dynamic Frequency
Search is enabled.
Run once in the next system boot.
49
BIOS Setup