Cpu_Fan1, Pump_Fan1, Sys_Fan1~4: Fan Connectors; Vraid1: Virtual Raid On Cpu Connector - MSI X299 GAMING PRO CARBON Présentation Rapide

CPU_FAN1, PUMP_FAN1, SYS_FAN1~4: Fan Connectors

Fan connectors can be classified as PWM (Pulse Width Modulation) Mode or DC Mode.
PWM Mode fan connectors provide constant 12V output and adjust fan speed with
speed control signal. DC Mode fan connectors control fan speed by changing voltage.
When you plug a 3-pin (Non-PWM) fan to a fan connector in PWM mode, the fan speed
will always maintain at 100%, which might create a lot of noise. You can follow the
instruction below to adjust the fan connector to PWM or DC Mode.
Important
You can switch between PWM mode and DC mode and adjust fan speed in BIOS >
y
HARDWARE MONITOR.
Make sure fans are working properly after switching the PWM/ DC mode.
y
Pin definition of fan connectors
PWM Mode pin definition
1 Ground
3 Sense

VRAID1: Virtual RAID on CPU Connector

This connector allows you to connect a VROC (Virtual RAID on CPU) Key module. You
need to enable the VROC function with Intel
enterprise) driver.
30
Overview of Components
Auto-detection Mode fan connectors
2 +12V
4 Speed Control Signal
1
3
The VROC key module is purchased separately.
1
CPU_FAN1/ PUMP _FAN1
1
SYS_FAN1~4
DC Mode pin definition
1 Ground
3 Sense
RSTe (Intel
® ®
1
Ground
Ground
Important
2 Voltage Control
4 NC
Rapid Storage Technology
2 VCC3
4 SATA_RAID_KEY