Attaching To Camera; Power Management - Hahnel MODUS 600RT MKII Manuel

Battery Level
Indication
3 bars
2 bars
1 bar
No bars
Blinking

Attaching to Camera

c

Power Management

Use ON/OFF Power Switch to power the flash unit on or off. Turn off if
it will not be used for an extended period of time. Setting as a master
flash, it will turn the power off automatically after a certain period
(approx. 90 seconds) of idle use. Pressing the camera shutter halfway
or pressing any flash button will wake up the flash unit. Setting as a
slave flash, it will enter sleep mode after a certain period (adjustable,
60 minutes by default) of idle use. Pressing any flash button will wake
it up.
Disabling Auto Power Off function is recommended when the flash
is used off camera. (C.Fn-APO)
Slave Auto Power Off Timer is set to 60 minutes by default. Another
option "30 minutes" is available. (C.Fn-Sv APOT, Page 33)
Modus 600RT
Meaning
Full
Middle
Low
Lower battery, please recharge it
The battery level is going to be used out
immediately.
Note: Please recharge the battery as soon
as possible (within 10 days). Then, the
battery can be used or stored as detailed in
the "How to store the battery" section.
a
b
1. Attach the Speedlight
to the camera.
Slip the flash's mounting foot
into the camera's hotshoe all
the way.
2. Secure the Speedlight Push
the release button to rotate
the lock ring on the mounting
foot until it locks in position
to the right.
3. Detach the Speedlight:
a) Push the release button.
b) Rotate the lock ring to
the left until it is loosened.
c) Slide the speedlight off the
camera hotshoe
15