Dometic GROUP WAECO CoolMatic CSMP2 Instructions De Montage Et De Service page 19

CoolMatic CSMP2
 Do not store any explosive substances such as spray cans with
propellants in the device.
!
CAUTION!
 Disconnect the device from the mains
– before cleaning and maintenance
– after use
 Food may only be stored in its original packaging or in suitable
containers.
A
NOTICE!
 Check that the voltage specification on the type plate
corresponds to that of the energy supply.
 The cooling device is not suitable for transporting caustic
materials or materials containing solvents.
 Disconnect the cooler and other power consuming devices from
the battery before connecting the quick charging device.
2.2 Operating the device safely
D
DANGER!
 Do not touch exposed cables with your bare hands. This
especially applies when operating the device with an AC mains
power supply.
A
NOTICE!
 In order to work properly, the cooler must have been standing
upright for at least an hour before you switch it on.
 The cooler has a built-in inclination sensor which switches it off
when it is tilted. Nevertheless, always switch off the cooler be-
fore tilting the cab.
Before switching the cooler on again, let it stand for at least
15 minutes after lowering the cab.
 Do not use electrical devices inside the cooler unless they are
recommended by the manufacturer for the purpose.
 Install the device in a dry location where it is protected against
splashing water.
 Do not install the device near naked flames or other heat sourc-
es (heaters, direct sunlight, gas ovens etc.)
EN
Safety instructions
19