Ayce ML-CS37-36 Manuel D'utilisation page 43

3 Plug the charging jack into the charging point on the docking station.
4 Place the screwdriver / torch onto the docking station to allow the tool to charge.
5 The docking station indicator lights illuminate in sequence, indicating the tool is
charging.
6 When the tool is completely charged, all 4 indicator lights will illuminate.
WARNING: Always charge the product before storage! To reduce risk of fire,
never leave the product connected with the USB charging cable for more than 24
hours!
CHANGING DRIVER BITS
Inserting Driver Bits
1 Insert the CRV bit directly into the magnetic bit holder.
2 Pull gently on the CRV bit to ensure it is properly secured.
Removing Driver Bits
Pull the CRV bit out of the magnetic bit holder to remove.
Forward/reverse rotation control
Change the rotational direction from forward to reverse by pressing the forward / reverse
control
1. Move the forward / reverse rotation control to the left in order to use the product in a
clockwise rotational mode. Use this function for screw driving.
2. Move the forward / reverse rotation control to the right in order to use the product in
anticlockwise rotational mode. Use this function to loosen jammed screws.
REV
FWD
85 |
86 GB GB DE GB IT