Ordinary Maintenance For The User; Allarm And Posible Faults - GGMgastro PEP Notice D'utilisation

ORDINARY MAINTENANCE FOR THE USER

As any equipment also our ovens requires simple, frequent and careful cleaning to ensure
efficient, regular functioning,
It is recommended to never use chemical products which are not specific for food
preparation areas, abrasives or corrosives for any reason. Avoid by all means using water
jets, tools, rough or abrasive instruments, such as steel wool, brillo sponges or any other item
which could damage the surface of the machine, and especially those that could
compromise health safety.
Oven external areas cleaning, external parts in stainless steel, door glass, and switch panel,
must be carried out at cold oven and at disconnected electric power supply.
Use a sponge or a soft cloth, not abrasive , slightly humidified with water or possibly with a
neutral detergent not corrosive. In any case, do not use water jets which can penetrate
through the electric parts and heavily damage them, as well as bring a possible danger for
people.
5 ALARM AND POSSIBLE FAULTS
Anomalies
The oven does not heat even though the
temperatures are set correctly.
The pilot lights are off.
The oven doesn't heat despite the main switch
is on (position 1) and the temperatures are
correctly set. The function pilot lights of the
heating elements are off.
The analogical thermometer doesn't notice the
increase of the temperature despite the heating
elements are correctly functioning
Inner light bulb does not switch on
Inner light bulb does not switch on
Inner light bulb does not switch on
The door is closed, but fume comes out
The baking chamber does not heat suitably
The baking chamber does not heat suitably in
spite of the temperature being set rightly
The temperature continues going up over the
set by thermostats
The door does not keep right closed
WORKING ANOMALIES
Possible Causes
Main switch in position "0"
No electric Energy in the net
Analogical thermometer defect
Burned inner light bulb
Inner light bulb switch defected
No electric supply power on the light
Exhauster butterfly valve closed
The set temperature are too low
One or more heating elements are
defected
Thermostat probe or thermostat
contacts defected
The door closing spring has subsiding
- 25 -
Turn the main switch in
contactor, the socket,
necessary replace the
bulb
Open more the valve
Replace the defecate
necessary replace the
disassemble the left
side panel and replace
Solutions
position "1"
Check the general
the plug, and the
supply cable.
Check and if
thermometer
Replace inner light
bulb
Replace light bulb
switch
Check electric
connection with the
light bulb
and check the right
functioning.
Set the right
temperature
heating elements
Check and if
thermostat/s
the spring