Publicité
Les langues disponibles
Les langues disponibles
PACKAGE CONTENTS
The package contains:
1 Router
3 Collets: 6mm,6.35mm, 8mm
1 Edge guide
2 Edge guide bars
1 Dust extraction adapter
1 Spanner
6 Router bits (optional, may not be available in all models)
1 Instruction Manual
•
Check for damage to the tool, parts or accessories which
may have occurred during transport.
•
Take the time to thoroughly read and understand this
manual prior to operation.
ELECTRICAL SAFETY
Your tool is double insulated; therefore no earth wire
is required. Always check that the main voltage
corresponds to the voltage on the rating plate.
WARNING! If the power cord is damaged, it must
be replaced by the manufacturer, authorized
Stanley Service Center or an equally qualified
person in order to avoid damage or injury. If the
power cord is replaced by an equally qualified
person, but not authorized by Stanley, the warranty
will not be valid.
USING AN EXTENSION CABLE
If it is necessary to use an extension cable, please used an
approved extension cable that fits the tool's power input
specifications. The minimum cross-sectional area of the
conducting wire is 1.5 sq. mm. Cables should be untangled
before reeling up.
Cable cross-sectional
2
area (mm
) Cable rated
current (Ampere)
0,75
1,00
1,50
2,50
4,00
7,5
Cable cross-sectional
2
area (mm
) Cable rated
current (Ampere)
6
10
15
20
25
Cable length (m)
15
25
30
45
60
(Original instructions)
Voltage
Amperes
110-127
0 - 2,0
2,1 - 3,4
3,5 - 5,0
5,1 - 7,0
7,1 - 12,0
12,1 - 20,0
220-240
0 - 2,0
2,1 - 3,4
3,5 - 5,0
5,1 - 7,0
7,1 - 12,0
12,1 - 20,0
FEATURES (FIG. A)
This tool includes some or all of the following features.
1. On/Off switch
2. Lock-off button
3. Variable speed control knob
4. Plunge lock lever
5. Spindle lock button
6. Collet
7. Revolver depth stop
8. Chip deflector
9. Depth stop bar
10. Depth of cut scale
11. Dust extraction adaptor
ASSEMBLY
WARNING! To prevent accidental operation, turn off and
unplug tool before performing the following operations. Failure
to do this could result in serious personal injury.
Fitting a router bit (Fig. B)
•
Remove the chip reflector (8).
•
Keep the spindle lock button (5) depressed and rotate the
spindle until the spindle lock fully engages.
•
Loosen the collet nut (12) using the spanner provided.
•
Insert the shank of the router bit (13) into the collet (6).
Make sure that the shank protrudes at least 3mm from the
collet as shown.
•
Keep the spindle lock button (5) depressed and tighten the
collet nut (12) using the spanner provided.
ENGLISH
Cable rated current (Ampere)
6
6
6
6
6
6
6
6
6
15
6
6
10
15
20
10
10
15
20
20
15
15
20
25
25
20
20
25
-
-
6
6
6
6
6
6
6
6
6
6
6
6
6
6
10
10
10
10
10
15
15
15
15
15
20
20
20
20
20
25
10
15
20
25
-
-
6
6
15
15
20
-
7
Publicité
