Warn 72504 Instructions D'installation page 5

V. INSTALLATION CONT.
Note: The following steps describe the method for raising the plow with a winch. If you are using an
electric actuator or manual lift, please follow the instructions included in those kits.
4. Attach the J-bolt bracket (C1) to the plow
cross-member using the supplied 3/8-16 X 1
hex bolt (B4), 3/8 flat washer (B5) and 3/8-
16 lock nut (B6) as shown in figure 4. The
bracket should be installed in the plow blade
side of the cross-member. Attach the 3/8 bolt
(B4) such that the head of the bolt is inside the
bracket and the threaded end points towards
the ATV.
5. Route the winch cable down over the roller
fairlead and to the J-bolt bracket. Slide the
loop end of the winch cable over the hook of
the J-bolt. If a winch hook is attached to the
loop end of the cable, position it out of the way
or remove it.
6. Slide the J-bolt down through the round hole
in the J-bolt bracket and terminate with the
supplied 1/4 flat washer (B8) and 1/4-20 lock
nut (B9) as shown in figure 5. The end of the
hook should be sitting in the slotted hole in the
bracket.
Note: If you're using a winch to lift the plow,
you will need a Roller Fairlead if one is
not already installed. A Cast-Iron Hawse
Fairlead will not work.
VI. MAINTENANCE/CARE
•
Inspect all metal parts on the plow, plow mount, and related hardware. Replace all parts that appears
rusted or deformed prior to use.
•
Inspect all nuts and bolts on the plow, plow mount, and related hardware prior to each use. Tighten all
nuts and bolts that appear to be loose. Stripped, fractured, or bent bolts or nuts need to be replaced im-
mediately.
•
Check all cables prior to use. Replace cables that are worn or frayed.
•
Check all moving and rotating parts. Remove debris that may inhibit the part from moving freely.
WARN INDUSTRIES
©2007 Warn Industries, Inc.
WARN® and the WARN logo are trademarks of Warn Industries Inc.
B4,B5 & B6
Figure 4 - J-Bolt Bracket
Figure 5 - J-Bolt Bracket and Winch
PAGE 5
C1
B7,B8 & B9
72503A1