Publicité
Les langues disponibles
Les langues disponibles
V. INSTALLATION
1. Remove the four bolts as shown in figure 1.
NOTE: Some models may require trimming
of plastic skid plate before mounting plow
mount.
2. Place the plow mounting base (A1) into
location as shown in figure 2. Secure with
four
5/16-18 X 1 1/2 hex bolts (B1), 5/16
flat washers (B2) and 5/16-18 lock nuts (B3) all
supplied in the plow mounting kit.
Note: Do not tighten at this time.
3. Place the plow mounting strap (A2) into
location as shown in figure 3. Secure with two
3/8-16 X 1 hex bolts (B4), 3/8 flat washers (B5)
and 3/8-16 lock nuts (B6).
Tighten all hardware at this time to the
recommended torque values listed on page 2
of this instruction.
WARN INDUSTRIES
©2007 Warn Industries, Inc.
WARN® and the WARN logo are trademarks of Warn Industries Inc.
Remove
Figure 1 - Remove Bolts
B1,B2 & B3
Figure 2 - Install Plow Mount
Figure 3 - Plow Mount Strap Location
PAGE 4
Remove
B1,B2 & B3
A1
A2
B4,B5 & B6
(both sides)
72503A1
Publicité
