Warn 72504 Instructions D'installation page 2

Failure to observe these instructions could lead to minor or moderate injury.
 Always take time to fully read and understand the installation and Operations Guide included with this product.
 Never operate this product if you are under 16 years of age.
 Never operate this product when under the influence of drugs, alcohol or medications.
 Always refer to the Installation and Specification Guide, supplied in the winch kit, forall wiring schematics and specific details
on how to wire this WARN product to your vehicle.
 Never overtighten the j-bolt to the bracket. Doing so will pinch the winch cable against the bracket, damaging the cable.
 Always put the end of the actuator cable through the slot in the Termination Bracket. Terminating the cable through any other
hole in the bracket will cause the bracket to not function properly and will drastically reduce the life of the actuator cable.
I. TABLE OF CONTENTS
Tools Required
Torque Specifications
Parts List
Installation
Maintenance/Care
II. TOOLS REQUIRED
- 13mm Wrench
- 13mm Socket
- 9/16" Wrench
- 9/16" Socket
- 1/2" Wrench
- 1/2" Socket
- Socket Wrench
III. TORQUE SPECIFICATIONS
5/16 17 lb. ft. (12.5 N-m)
3/8 30 lb. ft. (40.7 N-m)
WARN INDUSTRIES
©2007 Warn Industries, Inc.
WARN® and the WARN logo are trademarks of Warn Industries Inc.
Caution
Moving Parts Entanglement Hazard
Read installation and operating instructions thoroughly.
Notice
Equipment Damage
Read installation and operating instructions thoroughly.
page 2
page 2
page 3
page 4-5
page 5
PAGE 2 72503A1