Lux Tools A-FMR-20 Notice Originale page 15

Operation
Risk of injury! The device may only be put
into operation if there are no defects. If a part
is defective, it must be replaced before the
device is used again.
Risk of injury! The unit may only be used
with the additional handle mounted.
Check to make sure the device is in a safe operating
condition:
– Check to make sure there are no visible defects.
– Check to make sure all device components are
correctly mounted.
Switching on and off
Risk of injury! Wear goggles. Do not reach
into the operating stirrer. Always start mixing
with low revolutions.
– Hold the device firmly with both hands.
– Dip the stirrer vertically into the substance to be
mixed.
– To start the tool turning, press the On/Off
switch (7) with the switch lock (6) held down and
hold them down.
– To switch the device off, release the On/Off switch
(7).
Electronic control of revolutions
The unit is fitted with an electronic revolution control
function.
Risk of damage to the unit! The motor
may overheat in the event of permanent
heavy loads and low revolutions. Run the
motor at higher revolutions in idle to allow it
to cool down.
The revolutions can be set to any level you require
(revolution range: ► Technical data – p. 15).
– When inserting into/removing from the substance,
use low revolutions.
– During the mixing process, move the stirrer
around inside the container. Continue to mix until
all of the substance has been fully combined.
Error/Fault
Device does not work.
If you can't fix the fault yourself, contact your nearest
vendor. Please be aware that any improper repairs
will also invalidate the warranty and additional costs
may be incurred.
Cleaning
Cleaning overview
What?
Check the power cable
and plug for damage.
Regularly and according to the operating condi-
tions
What?
Clean the ventilation slots
of the motor to remove
dust.
Clean the device.
Storage, transportation
Storage
– Clean unit before storing.
– Store the tool in a dry and well ventilated place.
Transportation
– When dispatching, try to use the original packag-
Troubleshooting
What to do when something doesn't work...
Malfunctions are often caused by minor faults. You
can easily remedy most of these yourself. Please
consult the following table before contacting the ven-
dor. You will save yourself a lot of trouble and possibly
money too.
Cause
Is the device defective?
Battery pack discharged?
Battery pack defective?
Motor electronic faulty?
Technical data
Article number
Rated voltage
• maximum
• nominal
Risk of injury if switched on acciden-
tally! Pull out the power plug before con-
ducting any work on the device.
Risk of injury! Store the unit in such a way
that it cannot be started by unauthorised
persons.
Risk of damage to the device! Do not
stored unprotected in a damp environment.
ing, if possible.
Risk of injury! Unprofessional repairs may
mean that your device will no longer operate
safely. This endangers you and your envi-
ronment.
Remedy
Contact your local vendor.
► Charging the battery pack –
p. 14.
Contact your local vendor.
Contact your local vendor.
GB
How?
Conduct a visual inspec-
tion and have the cable
replaced by an electrician
if necessary.
How?
Use a vacuum or a brush
to clean out the ventila-
tion slots.
Wipe the unit with a damp
cloth.
129411
20 V
18 V
15