Lux Tools A-FMR-20 Notice Originale page 14

GB
The device is designed for mixing both liquid and
powder solvent-free products like paint, grout, plaster
and other similar substances.
The device may not be used for preparing foodstuffs.
The device is not suitable for mixing materials con-
taining powdered graphite, brine or slurry. Using it to
mix these substances may destroy the device.
• Symbols affixed to your device may not be
removed or covered. Information on the device
that is no longer legible must be replaced immedi-
ately.
Before putting the unit into operation, read
and observe the instructions for use.
Only re-charge the battery pack indoors.
Do not dispose of a battery pack with the
household waste!
Do not dispose of a battery pack in water!
Do not burn the battery pack!
Do not expose the battery pack to sunlight
or increased temperatures!
MAX xx °C MAX xx °C
Personal protective clothing
There are risks caused by spraying of the
substance you are mixing! Wear goggles.
When working with dusty substances, wear
a dust protection mask.
When machine parts rotate, do not wear
gloves.
An overview of your unit
The actual appearance of your product may
differ from the illustrations.
► P. 3, item 1
1. Stirrer basket
2. Mixer shaft
3. Tool receiving socket
4. Revolution regulator
5. Handle
6. Switch lock
7. On/Off switch
8. Battery pack (not included in the scope of deliv-
ery)
Battery pack (not included in the scope of
delivery)
► P. 3, item 2
9. Display for remaining capacity
10. Button for remaining capacity
11. Locking button
14
Battery charger (not included in the scope of
Paint and cement stirrer Original instructions
delivery)
► P. 3, item 3
12. Control light
Scope of delivery
• Paint and cement stirrer
• Mixing paddle
• Mixer shaft
• Operating instructions
Installation
Risk of injury if switched on acciden-
tally! Pull out the power plug before con-
ducting any work on the device.
Mounting the stirrer basket
– Screw the mixing shaft (2) to the tool holder (3).
– Counter hold the tool holder using a 17 AF open-
ended spanner and tighten the mixing shaft using
a 22 AF open-ended spanner.
– Screw the mixing paddle (1) to the mixing
shaft (2).
Using for the first time
Charging the battery pack
Rechargeable battery and charger are not
part of the scope of delivery and are availa-
ble optionally from your dealer (► Acces-
sories – p. 16).
Risk of injury! Comply with all safety
instructions when handling rechargeable
devices.
Risk of damage to the unit! Do not allow
the battery pack to deep discharge.
If the battery is fully loaded, the charger
automatically switches over to the mainte-
nance charge function. The battery can thus
remain in the charger permanently.
The battery pack must be charged prior to the first
start-up (charging time: ► Technical data – p. 15).
► P. 4, item 4
– Press in the locking button (11) and remove the
battery from the device.
► P. 4, item 5
– Insert the battery pack into the charger.
– Plug the charger into the power supply.
The charging status is displayed by the control
light (12).
Checking the remaining capacity of the battery
– Press the button (10).
The remaining capacity of the battery is displayed by
the control lights on the display (9).