Klarfit Pacemaker X3 Mode D'emploi page 26

EN
26
OPERATING THE COMPUTER
Activating the device:
Insert the plug into the socket
and set the switch on the front
right-hand side to position "1".
As soon as the unit has been
activated, a short tone sounds
to indicate that the unit is in
standby mode.
Place the safety cord on the
magnetic surface. (If this
safeguard has not been fitted, the
display shows "- - -".)
Start the tape:
Press the start button. The display counts down and a triple beep sounds.
The belt starts at the lowest speed (0.8 km/h). The preset programme is 60
minutes.
Change the speed
There are several ways to change the speeds:
• Increase or decrease the speed with the (+) / (-) buttons on the control
panel.
• Change directly to 3 km/h, 5 km/h or 7 km/h with the quick selection
buttons.