Sunny SF-E3890 Mode D'emploi page 13

We value your experience using Sunny Health and Fitness products. For assistance with parts or
troubleshooting, please contact us at support@sunnyhealthfitness.com or 1-877-90SUNNY
(877-907-8669).
ASSEMBLY INSTRUCTION
12
STEP 1:
Remove the preassembled 8 Screws
(No. 16), 8 Flat Washers (No. 19), 8
Spring Washers (No. 17) and the
shipping tubes (A) from the Main
Frame (No. 1) using Allen Wrench
(No. 94).
Attach the Front Stabilizer (No. 3)
and Rear Stabilizer (No. 4) onto the
Main Frame (No. 1), secure with 8
Screws (No. 16), 8 Flat Washers
(No. 19) and 8 Spring Washers (No.
17) that were just removed, tighten
with the Allen Wrench (No. 94).
Note: You may discard shipping
tubes (A) or save them to repackage
the item in the future.
STEP 2:
Connect the Extension Wire (No.
18) and Sensor Wire (No. 20).
Remove the preassembled 6 Screws
(No. 16), 6 Spring Washers (No. 17)
and 6 Arc Washers (No. 13) from
the Main Frame (No. 1). Insert the
Handlebar Post (No. 2) into the post
of the Main Frame (No. 1); secure in
place with 6 Screws (No. 16), 6
Spring Washers (No. 17) and 6 Arc
Washers (No. 13) that were just
removed using Allen Wrench (No.
94).
Remove 4 Screws (No. 46) from the
Front Tube Covers (No. 44L/R) with
Spanner (No. 93). Then attach the
Front Tube Covers (No. 44L/R) to
the Main Frame (No. 1) with 4
Screws (No. 46) that were just
removed using Spanner (No. 93).