Turbosound NuQ62-FY Mode D'emploi page 4

6
NuQ Brackets
Bracket Assembly
NuQ62-FY
• Mount the bracket to the ceiling or wall in desired location.
Lift the speaker into the bracket and attach the included screws on either
•
side. Position the speaker angle before tightening.
NuQ62-SB
Mount the bracket to the ceiling or wall in desired location.
•
Attach the smaller bracket joints to the top and bottom of the speaker with
•
the included M8x12 bolts.
Lift the speaker into the bracket and attach the M8x16 screws to the bracket
•
and bracket joints. Position the speaker angle before tightening.
NuQ82/102/122/152-FY
Attach one of the side plates to the bracket by sliding the threaded screw of
•
the plate through the hole in the bracket arm.
Place one of the larger 13 mm flat washers over the threaded screw, followed
•
by a 13 mm spring washer, followed by another 13 mm flat washer.
Lightly screw one of the knobs onto the threaded screw to secure the plate to
•
the bracket.
• Repeat the above steps to attach the other side plate to the bracket.
Mount the bracket assembly to the ceiling or wall in desired location.
•
Place one of the smaller 10 mm spring washers onto one of the M10 screws,
•
followed by a 10 mm flat washer. Repeat for the other 3 screws.
Lift the speaker into the bracket assembly and attach the screws through the
•
side plates and into the threaded inserts in the side of the speaker. Position
the speaker angle before tightening the side knobs.
NuQ82/102-SB
Mount the bracket to the ceiling or wall in desired location.
•
• Insert the swivel holder into the speaker pole socket on the bottom of
the speaker.
One arm of the bracket has 2 holes side-by-side at the end, while the other
•
arm has one hole. Lift the speaker into the bracket so that the bottom of the
speaker faces the bracket arm with 2 holes at the end.
Attach the larger M5 screws through the 2 holes and into the swivel holder.
•
Lightly screw the plastic handle screw through the other bracket arm and
•
into the top of the speaker. Position the speaker angle before tightening the
handle screw.
Insert the M4 screws through the remaining holes in the bracket arm and
•
into the speaker to solidify the speaker angle.
NuQ82/102-EB
Mount the SB bracket to the ceiling or wall in desired location.
•
Insert the swivel holders into the speaker pole socket on the bottom of
•
each speaker.
While installing the first speaker into the bracket as described in the SB
•
instructions, include the extension arms on the outer side of the bracket
before the screws and knob are installed. Make sure the extension with
the 2 diagonal slots goes on the side where the bottom of the speaker is
attached.
After the first speaker is installed, lift the second speaker into the
•
extension arms and repeat the installation steps. The angle of the extension
arms and of the second speaker can be adjusted before tightening the
respective screws.
7
Quick Start Guide