Publicité
Les langues disponibles
Les langues disponibles
5
6
7
8
8ft.6in. x 67in. x 24in. (2.59m x 1.70m x 61cm)
8ft.6in. x 67in. x 24in. (2.59m x 1.70m x 61cm)
FILLING POOL WITH WATER
ATTENTION:
Do not leave pool unattended while filling with water
1. Fill pool to drain valve.
STOP
2. Turn water off. Check that the water is not collecting on any side to ensure the pool is level. If pool is not level, drain
water and re-level ground by digging out. Never attempt to move the pool with water in it, serious personal injury or
damage to the pool may result.
NOTE:
Your pool may contain a great deal of pressure. If your pool has any bulge or uneven side then the
pool is not level, the sides may burst and the water may discharge suddenly causing serious personal injury and/or
damage to property.
3. If level, fill pool to lowest pump valve.
STOP
4. Turn water off. Check valves for secure fit.
5. Fill pool until water capacity is 90%, DO NOT OVERFILL as this could cause the
pool to collapse. In times of heavy rainfall you may need to empty some of the
water to ensure the level is correct.
6. Check pool for any leaks at valves or seams, check ground cloth for any evident
water loss. Do not add chemicals until this has been done.
7. In the event of a leak, patch your pool using the underwater adhesive repair patch provided. Refer to the FAQ's for
further information.
Proper Water Level
NOTE:
Drawings for illustration purpose only. May not reflect actual product. Not to scale.
ATTENTION:
Do not use pump when pool is in use.
During the season of use of the swimming pool, the filtration system must be necessarily put into service every day,
enough for a long time to assure at least a complete renewal of the volume of water.
Pool Maintenance
If you do not adhere to the maintenance guidelines below, your health might be at risk, especially that of your children.
IMPORTANT:
If you don't respect the ideal values of the water chemicals the PVC can be damaged and
become discolor.
The following table lists the sequence of the tests that should be carried out for the ideal values and possible actions.
Regularly check the pH value and chlorine concentration weekly and adjust to the ideal values.
TEST
IDEAL VALUES
pH value
7.4– 7.6
Cyanuric acid
30 – 50 ppm
Free chlorine
2 – 4 ppm
Chlorine compound
0
Algae
None visible
Calcium hardness
200 – 400 ppm
To keep your pool clean:
1. Contact your local pool supply shop for advice and purchase of chemicals and pH kits. One of the most important
factors to increase the life of the liner is to keep continously clean and healthy water.
Please strictly follow the instructions from professional technicians for the water treatment through the use of
chemicals.
2. Locate a bucket of water next to pool to clean users' feet before entering pool.
3. Cover the pool when not in use.
4. Skim pool regularly to avoid settled dirt.
5. Check and wash the filter cartridge regularly.
6. Gently clean any scum from below the top ring with a clean cloth.
7. Please be careful in case of rain water, kindly check that the water level is not higher than the expected. If so, YOU
HAVE TO DISCHARGE THE EXCESS WATER.
Proper maintenance can maximize the life of your pool.
During the season of use of the swimming pool, the filtration system must be necessarily put into service every day,
enough time to assure at least a complete renewal of the volume of water.
Repair
Check pool for any leaks from valves or seams, check the ground cloth for any evident water loss. Do not add
chemicals until this has been done.
NOTE:
In the event of a leak, patch your pool using the underwater adhesive repair patch provided. Refer to the
FAQs for further information.
Dismantling
1. Unscrew the drain valve cap on the outside of the pool counter clockwise and remove.
2. Connect the adaptor to the hose and put the other end of the hose in the area where you are going to drain your
pool. (Check local regulations for drainage by-laws).
3. Screw control ring of the hose adaptor onto the drain valve clockwise. The drain valve will be open and water will
ATTENTION:
start to drain automatically.
4. When draining is finished, unscrew the control ring to close the valve.
5. Disconnect the hose.
6. Screw the cap back onto the drain valve.
7. Air dry pool.
ATTENTION:
Do not leave the drained pool outside.
Storage and Winterization
1. Please remove all the accessories and spare parts of the pool and store them clean and dry.
2. Once pool is completely dry, sprinkle with talcum powder to prevent pool from sticking together, fold pool carefully. If
pool is not completely dry, mold may result and will damage the pool liner.
3. Store liner and accessories in a dry place with a moderate temperature between 5ºC / 41ºF and 38ºC / 100ºF.
4. During the rainy season, pool and accessories should be stored as per above instructions also.
5. Improper draining of the pool might cause serious personal injury and/or damage to personal property.
6. We strongly recommend the pool is disassembled during the off season (winter months). Store in a dry location out
of children's reach.
5
0°
Water flow can be controlled with the control ring.
S-S-004972
Publicité
