Power Connections, Display And Keypad - Control Techniques COMMANDER SE Guide Rapide

+
Optional
Braking
Resistor
200 - 240V AC, 1 phase & 3 phase: 200V AC units
(single phase up to 2.2kW, connect supply to L1 and L2)
380 - 480V AC, 3 phase: 400V AC units only
TO OPTIMISE PERFORMANCE, SET MOTOR MAP:
Parameter 6. Enter motor rated current in amps from motor nameplate.
Parameter 7. Enter motor rated speed in rpm from motor nameplate.
Parameter 8. Enter motor rated voltage in volts from motor nameplate.
Parameter 9. Enter motor power factor from motor nameplate.
Sign LED
Run key,
Use to start drive
in keypad mode.
Increase and decrease keys
Use to select and edit
parameters, also to vary
motor speed in keypad
control.
POWER CONNECTIONS
Commander SE size 1
L1 L2/N PE U
INPUT VOLTAGE
200-240V AC, 1 phase
Commander SE sizes 2, 3 & 4
DBR
L1 L2
INPUT VOLTAGE
DISPLAY AND KEYPAD
I
W
V
M
L3 PE U
.
O
M
2
W
V
M
Stop / Reset key,
Use to stop the drive in
keypad mode and to reset
the drive in any mode.
Forward/Reverse key,
Use to reverse motor
direction in keypad mode
when bit parameter 26=On.
Mode key,
Use to change mode
of operation of display.
Parameters are saved each
time the Mode key is pressed