Publicité
Les langues disponibles
Les langues disponibles
EN
ENGLISH
INTRODUCTION
This instruction sheet provides you with the information required
to safely own and operate your Little Giant® product. Retain these
instructions for future reference.
The Little Giant® product you have purchased is of the highest quality
workmanship and material, and has been engineered to give you long
and reliable service. Little Giant® products are carefully tested, inspected,
and packaged to ensure safe delivery and operation. Please examine
your unit carefully to ensure that no damage occurred during shipment.
If damage has occurred, please contact the place of purchase. They will
assist you in replacement or repair, if required.
READ THESE INSTRUCTIONS CAREFULLY BEFORE ATTEMPTING TO
INSTALL, OPERATE, OR SERVICE YOUR LITTLE GIANT® PRODUCT.
KNOW THE PRODUCT'S APPLICATION, LIMITATIONS, AND POTENTIAL
HAZARDS. PROTECT YOURSELF AND OTHERS BY OBSERVING ALL SAFETY
INFORMATION. FAILURE TO COMPLY WITH THESE INSTRUCTIONS COULD
RESULT IN PERSONAL INJURY AND/OR PROPERTY DAMAGE!
SAFETY GUIDELINES
WARNING
MAKE CERTAIN THAT THE UNIT IS DISCONNECTED FROM THE POWER
SOURCE BEFORE ATTEMPTING TO SERVICE OR REMOVE ANY COMPONENT!
1. Choose a location for both safe and easy installation and avoid areas
with chemicals, explosives or other dangerous materials.
2. Do not handle the lights with wet hands or when standing on
a wet or damp surface, or in water.
2
ELECTRICAL CONNECTIONS
WARNING
1. The lights are rated 3 W, 12 VAC, 60 Hz. DO NOT connect to voltage
other than the stated voltage.
2. Connect the fixture to a suitable 12 VAC 60 Hz transformer. In Canada,
the luminaire must be connected/supplied from a CSA Certified
Class II supply with a double-insulated transformer or a transformer
with a grounded shield between the primary and secondary
windings of the transformer. The Little Giant® item number 950887
meets these requirements.
3. Please note that this light was designed to be used with a
conventional linear or magnetic transformer. Use of other
types of transformers may limit light functionality.
OPERATION
WARNING
NOTE: These lights can be used completely submerged or
out of water.
1. To connect the light, refer to the instructions included with
your transformer.
2. Always carry the light by its housing and not by its connection cable.
3. Select a location for both safe and easy installation and avoid areas
with chemicals, explosives or other dangerous materials.
4. Select the appropriate mounting bracket. The small pipe bracket is
for use with fountain heads. It can also be used on any pipe with an
approximate O.D. of 0.84". The large pipe bracket can be used on any
pipe with an approximate O.D. of 1.32". Install the bracket as shown
in Figure 1.
5. If instability occurs due to the light's buoyancy, rocks or bricks
may need to be placed around or on top of the bracket to provide
additional support.
6. DO NOT let the unit freeze. This may cause cracking or distortion that
can destroy the unit or cause safety problems.
7. The LED has eleven pre-programmed operation modes to choose
from. Refer to the Operation Mode table for a description of the
operating modes.
Publicité
