Publicité
Les langues disponibles
Les langues disponibles
2. Installation
1. After separating the Speed Sensor coupler, plug in both the male and female 3-pole SH harness
connectors. Make sure the connectors are fully seated.
2. Connect the 4-pole SH harness connector to the SH box.
3. Check whether the SH is installed and working properly:
-
Have the ignition OFF.
-
Press SEL and keep it depressed while you turn ignition ON.
[ t ] (test) is now indicated. Release the button.
The speedo should indicate a number other than zero
-
Rotate the rear wheel.
[ t ] should be blinking as the wheel turns.
-
Press SEL to exit from Test mode.
The speedometer should work the same way as with no SH installed
If the tests fall, disconnect the 3-pole and 4-pole connectors and check whether the connector pins
are bended or pushed out of position.
4. Find a place in your bike for the SH box regarding the followings.
-
To be able to change the settings easily, place the unit where it is quickly accessible.
-
Frequently wet areas should be avoided.
-
Do not place the unit very close to hot places like the engine or exhaust pipe.
-
Keep at least 2 cm (1") distance from other electronics, such as the bike's ECU or Power
Commander.
In most cases, the under-seat compartment is the location for the box.
Secure the unit with the supplied Velcro strips.
5. Neatly route the SH harness from the 3-pole plugs to the mounting location, preferably alog the
frame. To reduce possible interference, try not to route the SH harness along with other electrical
cables.
Do not bend the SH harness near the SH connector. Otherwise the pins may break over time.
6. Connect the 2-pole plug of the remote button. Route the harness towards the front end of the bike
and secure the remote button at the dashboard with the supplied
If you wish, you can easily change the harness length or replace the remote button per your liking
(any SPST momentary "push-to-make" switch can be used).
7. Please visit www.speedohealer.com and use our on-line calculator to generate set-up instructions
for you SH. Alternatively refer to the User's Guide for instructions.
Publicité
