Publicité
Les langues disponibles
Les langues disponibles
For use with the following HONDA motorcycles:
CBR600F3 (1995-1998), CBR600F4 (1999-2000), CBR600F4i (2001-2006), CBR600FS (2001-2003),
CBR600RR (2003-2004), CBR900RR Fireblade (1994-1999), CBR929RR (2000-2001), CBR954RR
(2002-2003), CBR1100XX Blackbird (1996-2008), ), CBR1100SF X-11 (1999-2002), 599 (2002-2006),
CB600F Hornet (2003-2006), 919 (2002-2008), CB900F Hornet (2002-2008), CB400 (2001-2008),
CB1300 Super Four (1998-2008), CBF500 (2004-2008), CBF600 (2004-2008), CB1800 Goldwing
(2001-2008),
VFR750
FireStorm/SuperHawk (1997-2005), RVT1000R RC51 (2000-2006), VTR1000 SP1/SP2 (2000-2006),
ST1300 Pan European (2002-2008), VT125C Shadow (1999-2008), X-4 (1997-2003), XL125V
Varadero (2001-2008), XL1000V Varadero (1999-2004),
Disclaimer: Dot not attempt to install the product if you don't have basic mechanical skills.
The SeepdoHealer is intended to improve speedometer accuracy. However, healTech Electroniques Ltd.
and its distributors shall not be liable for any loss, damage or penalties caused by improper installation
or inaccurate speed-readings.
1. Locating the Speed Sensor coupler
Preparation:
-
The ignition key should be in OFF position.
-
Raise the rear wheel off the ground by using a stand.
Make sure the rear wheel spins freely.
-
Remove the seat.
The Speed Sensor is usually located on the top, or the side of the gearbox and reads the revolution of
the countershaft.
The 3-pole speed sensor coupler is situated 10-30 cm (4"-12") away from sensor.
The connector is usually accessible by raising the fuel tank or removing a side fairing.
If the speedometer is driven off the front wheel, the sensor coupler is usually in the headlight bucket.
You might find information about the location of the speed sensor coupler specific for your bique
model on our web: http://www. Speedohealear.com
If in doubt, check the bike's Service Manuel or ask your dealer for the location of the Speed Sensor
coupler.
Confirmation:
Separate the Speed Sensor coupler (you might need to use a small flathead screwdriver to get the
coupler apart). Rotate the rear wheel while the ignition is on.
Does the speedometer show 0, turn the ignition off and proceed to the next step.
Otherwise, try again since you have disconnected something else.
SPEEDOHEALER V4
Install Guide
SH-H01
(1994-1997),
VFR800
Harness Kit
Interceptor
(1998-2006),
VTR1000F
Publicité
