Ignition Switch - Maxx 21038 Mode D'emploi

HEDGE TRIMMING TECHNIQUES
Trim sides of a hedge first, and then the Top.
Vertical cut:
• With the 2-sided blade model 2 1038 use an arcing cut from the
bottom upwards, then downwards to use both sides of the blades (OP7).
Horizontal cut:
• In order to get the best cutting results, slightly tilt the blade (5°–10°)
towards the cutting direction (OP8). Cut slowly, specially with thick hedges.
WARNING
Always follow the safety precautions.
The hedge-trimmer must only be used to trim hedges or small bushes.
It is forbidden to cut other types of material. Do not use the hedge-trimmer
as a lever to lift, move or break objects, nor lock it on fixed s upports.
It is forbidden to apply tools or applications that are not the ones indicated
by the manufacturer onto the hedge-trimmer's power take-off.
Do not use it for pruning trees or cutting grass.
8. MAINTENANCE
Maintenance, replacement, or repair of the emission control device and systems may be
performed by any non-road engine repair establishment or individual.
MAINTENANCE CHART
SYSTEM/COMPONENTS
fuel leaks, fuel spillage
E
fuel tank, air filter, fuel filter
N idle adjusting screw
G
spark plug
I
N
cylinder fins, intake air
cooling vent
E
muffler, spark arrester,
cylinder exhaust port
T throttle lever, ignition switch
R
cutting parts
I
M gear case
M
screws/nuts/bolts
E
debris guard
R
PROCEDURE BEF EVERY
ORE 25
use HOURS
AFTER
a
wipe out
a a
inspect/clean
a
see adjusting
idling speed
clean and readjust
plug gap
a
clean
clean
a
check operation
a
replace if
something's wrong
a
grease
a
tighten/replace
a
make sure to
attach
EVERY EVERY NOTE
50 100
HOURS HOURS
AFTER AFTER
replace, if necessary
replace carburetor
if necessary
a
GAP : 0.65 mm
replace, if necessary
a
a
not adjusting screws
43