Using The Spa - Bestway LAY-Z-SPA VANCOUVER AIRJET PLUS S100201 Mode D'emploi

USING THE SPA

A. LOCK/UNLOCK BUTTON: The pump has a 5-minute auto-lock, this
light will turn on. To lock or unlock the pump, place a finger over the
lock/unlock button for 3 seconds.
B. POWER-SAVING TIMER BUTTON: Designed to help avoid wasting
power by setting the time and duration of the heating cycle for the spa.
This way, you can enjoy your spa at the time you desire, without needing
to leave the heater on at all times.
STEP 1: Set the heating duration
1. Press the
2. Press the
3. Press the
STEP 2: Set the number of hours FROM NOW when the heater will activate
1. After setting the heating duration, the
2. Press the
3. Press
LED will light steadily, and the countdown to heater activation will begin.
To modify the timer settings: Press the
Cancel the setting: Press the
NOTE: After setting, the screen flashes the current temperature and time alternately.
NOTE: Timer adjustment (amount of time with the heater ON) may be set from 1 to 999 hours;
Reservation time adjustment (the number of hours FROM NOW when the heater will begin to
function) may be set from 0 to 999 hours. If the timer is set at 0 hour, the heating system will
activate immediately.
Note that the timer is one time per use - the user sets the duration of the heating cycle, and
how many hours from now the heating cycle begins. The timer does NOT repeat until reset.
C. HEAT BUTTON: Use this button to activate the heating system. When
the light above the heat button is red, the heating system is activated.
When the light is green, the water is at the set temperature and the
heating system is at rest.
NOTE: If the heating system is activated the filtration system will
automatically start.
NOTE: After turning off the heating system the filtration system will
continue to operate.
NOTE: If the spa heater is on when the water temperature is below
6ºC(42.8°F), the heating system will warm the water until 10ºC(50°F)
automatically.
D. MASSAGE SYSTEM BUTTON: Use this button to activate the
massage system, which has a 30-minute auto-shutoff feature. The light
above the Massage System Button displays red when activated.
IMPORTANT: Do not run the Massage system when the cover is
button unit the LED starts to flash.
or button to adjust the heating duration (From 1-999 hours).
button again to confirm the heating duration.
or button to adjust the hours until time of activation (From 0-999 hours).
button again or simply touch nothing for 10 seconds to confirm the setting. The
button for 2 seconds.
A
B
C
D
LED starts to flash.
button and use the
19
or button to adjust.
E
F
G
H
I
J