Publicité
Les langues disponibles
Les langues disponibles
Support Installation
Align the Column Pipe with
holes on the support and
tighten screws.
Considerate Hint:
Remove ①②parts from the
component before performing
installation.
Loosen the clamp and extend the top part of the tube completely and block the tube at this
height by tightening the clamp again.
Make sure that the clamp is tightened before mounting the motor. Loosen the large screw
at the back of the control panel (a). Place the motor on the telescopic tube. Tighten the large
screw again, making sure that the screw is aligned with the recess in the telescopic tube. The
large screw must be fully tightened prior to using the fan.
FASTENING THE GRILL AND THE FAN BLADES
Place the back of the grill on the motor drive. Secure it using the open plastic screw. Place the
fan blades on the motor drive. Make sure the pin on the motor drive fits perfectly behind the
fan blades. Secure the fan blades on the motor drive using the closed plastic screw.
30
DO8141
① ①
Rear grill
a
Support Installation
Align the Column Pipe with
holes on the support and
tighten screws.
Blade
Pull the blade to rotate after installing,
so as to ensure that the blade can be
normally rotated.
Lock nut of grill
Screw the lock nut of grill clockwise,
and in the meantime, fix the rear grill.
Considerate Hint:
Remove ①②parts from the
component before performing
installation.
① ①
Lock nut of blade
Lock nut of blade
anticlockwise,
and then install the
front fan cover.
Publicité
