Publicité
Les langues disponibles
Les langues disponibles
Glass
Lens
Hook
Notch
Figure 14
4.
Plug cord from lamp holders into the appropriate receptacle.
5.
Line up slots in the grill with lances on inside of housing. Insert included #8 screws
through grill slots and into housing lances. Tighten both screws until the grill fits snugly
to the ceiling. DO NOT OVER TIGHTEN (Figure 15).
Figure 15
NOTE: Diagram is a representation of actual grill. Your unit's grill may vary.
5a. AKLC70RCB Only: Install the included light fixture mounting bracket to the fan housing
by lining up the holes in the bracket with the lances on the fan housing. Using the
included #8 screws attach the bracket to the housing. DO NOT OVERTIGHTEN.
Line up the hole in the grill to the threaded insert on the light fixture mounting bracket.
Using the included screw and washer, secure the light fixture to the bracket (Figure 16).
Threaded Insert
Figure 15
CAUTION:
FAILURE TO SECURE THE GRILL MAY RESULT IN A
RATTLING OR HUMMING NOISE.
6.
Install the appropriate number of 60 watt maximum, type A19 medium base
incandescent bulbs (not included).
7.
Reinstall the lens in place by reversing the directions in Step 3.
8.
Restore power and test your installation.
6728087 Rev. D 1-16
Tension
Spring
Glass Lens
Lances
#8 Screws
Lances
Bracket
#8 Screws
SECTION 7
Use and Care
Cleaning the Grill: Refer to instructions in Section 6 Completing the Installation, to
1.
remove grill and glass light lens. Use a mild detergent, such as dishwashing liquid,
and dry with a soft cloth. NEVER USE ANY ABRASIVE PADS OR SCOURING POWDERS.
Completely dry all parts before reinstalling. Refer to instructions in Section 6 Completing
the Installation, to reinstall grill and glass light lens.
2.
Cleaning the Fan Assembly: Wipe all parts with a dry cloth or gently vacuum the fan.
NEVER IMMERSE ELECTRICAL PARTS IN WATER.
CAUTION:
Changing the Light Bulb: Disconnect power to the unit. Remove light lens from grill by
3.
following the instructions in Step 3 of SECTION 6 - Completing the Installation. Replace
light bulb(s) with the appropriately bulb(s) as marked on the light receptacle.
Reinstall the lens by reversing the instructions in Step 3 of SECTION 6 - Completing the
4.
Installation.
CALIFORNIA RESIDENTS ONLY:
WARNING:
CHEMICALS] KNOWN TO THE STATE OF CALIFORNIA TO CAUSE CANCER.
Grill
WARNING:
[OR CHEMICALS] KNOWN TO THE STATE OF CALIFORNIA TO CAUSE
REPRODUCTIVE TOXICITY.
Grill
www.airkinglimited.com
CAUTION:
MAKE SURE POWER IS SWITCHED OFF AT
SERVICE PANEL BEFORE STARTING INSTALLATION.
ALLOW BULBS TO COOL BEFORE REPLACING.
THIS PRODUCT CAN EXPOSE YOU TO A CHEMICAL [OR
THIS PRODUCT CAN EXPOSE YOU TO A CHEMICAL
4 of 12
Publicité
