Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
3.
Place one of the 1-1/8" wrenches on the flats of the chuck with the opposite
end of the wrench resting on the bench to your left (Fig. 4).
4.
Place the other 1-1/8" wrench on the collet nut and tighten securely by
turning COUNTER-CLOCKWISE (Fig. 4).
INSTALL THE TABLE TOP
1.
Tilt the cabinet assembly onto its back
(Fig. 5).
2.
Position the table top to the top of the
cabinet assembly (Fig. 5).
3.
Use four 1/4" x 5/8" machine screws
to secure the table top to the cabinet
assembly. Insert the screws through the
bottom of the cabinet assembly (Fig. 6).
Start all four screws and then tighten each
securely with a phillips screwdriver
INSTALL THE FEET
NOTE: Position the cabinet assembly on its
back as described in step #1 of "INSTALL THE
TABLE TOP" Section.
1.
Locate four feet, four flat washers, and four
5/16-18 hex nuts.
2.
Position the stud on one of the feet through
one of the four holes in the base of the
cabinet (Fig. 7).
3.
Place a flat washer onto the stud and secure with one of the hex nuts. Tighten
firmly.
4.
Repeat steps 2 and 3 to attach the three remaining feet (Fig. 8).
Fig. 7
INSTALL THE DRILL MOTOR
NOTE: Position the cabinet assembly on its back as described in step #1 of
"INSTALL THE TABLE TOP" Section.
1.
Place the 1/4-20 x 1/2" flathead motor mounting screw onto the 5/32" hex
wrench (Fig. 9).
Never tighten collet without bit inserted, to do so may cause
damage to the collet.
Disconnect the drill motor and machine from the power
source and place switches in the "OFF" position.
Fig. 5
.
Fig. 6
Fig. 8
12
Publicité
Table des Matières
