Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
R
einsTalling The
After the moving the refrigerator to the location where it will be
used, reinstall the door(s) and freezer drawer front.
1. Slide the screws on the back of the drawer front into the slots in
the drawer brackets on both sides. You may need to move the
bottom of the bracket around slightly to get the slot to line up
with the screw.
2. Tighten the four front panel screws completely. Do not over-
tighten.
3. Place the freezer basket back
onto the drawer slides.
i
nsTallaTion
d
f
RaweR
RonT
i
nsTRuCTions
R
einsTalling The
Install the hinge assemblies:
1. Install the top hinge loosely using the
existing 5/16" hex head screws.
2. Install the center hinge using the existing
Phillips screws.
top hinge
3. Place the hinge side of the refrigerator
door on the center hinge pin.
4. While holding the refrigerator door
upright, tighten down the top hinge with
a 5/16" hex head driver.
5. On 3 door (french door) models,
reconnect the wiring plug located on
top of the left top hinge.
6. Replace the hinge cover using the
existing Phillips screw.
d
(
)
ooR
s
center hinge
hinge Pin
Wiring Plug
hinge cover
5
Publicité
Chapitres
Table des Matières
