Setting The Signal Type - SilverCrest STK 36 B2 Instructions De Montage, D'utilisation Et Consignes De Sécurité

Note: The synchronisation mode can only last for approx. 2 minutes.
If you cannot synchronise your transmitter and receiver, please enter
synchronising mode again.
Note: Wait for approx. 2 minutes after the transmitter and receiver
have been successfully synchronized until the signal indicator
receiver goes out.
Note: If the synchronization between transmitter and receiver is
cancelled, you can remove the battery in the receiver.

Setting the signal type

The receiver can indicate the reception of a door signal either optically
or acoustically or both optically and acoustically.
Using the signal type selector button
is to be indicated optically or acoustically or both optically and
acoustically.
Note: When the battery of receiver is drained, signal indicator
will flash. You can replace the used battery with a new one of the
same type.
, select whether the signal
3
on the
1
1
GB/IE/NI 15