Operation; Synchronising Transmitter / Receiver - SilverCrest STK 36 B2 Instructions De Montage, D'utilisation Et Consignes De Sécurité

Remove the used batteries, if present.
Insert a battery (3 V
The side marked "+" must face upwards.
Fasten the holder
back of the product.
The transmitter battery compartment with the holder
stalled by the screw
stop using the product.

Operation

Synchronising transmitter / receiver

Synchronise the transmitter and receiver as follows:
As soon as the batteries are installed, the receiver enters synchronis-
ing mode.
You can also manually enter synchronising mode by holding the
synchronising button
The signal indicator
Press the chime button
will illuminate once.
The signal indicator
cate the synchronisation is successful.
14 GB/IE/NI
(direct current), type CR 2032).
and screw
15 18
while in use. If the holder
18
for approx. 3 seconds.
7
on the receiver will light on.
1
, the signal indicator
11
on the receiver will then blink. This is to indi-
1
of the transmitter back on to the
15
on the transmitter
12
must be in-
15
is damaged,