Techno Line WS6767 Mode D'emploi page 16

Sensor ReceptIon

Press and hold the "CH" button for 3 seconds to search for the sensor .

The strengh signal icon will flash utill the sensor signal is received for 3 minutes if no available.
RF signal icon：
Adding additional sensors：
1. Make sure channel 2 or 3 is displayed on the weather station.Press the "CH" button to change channels on the weather
station.
2. Make sure the channel selector switch the sensor 2 or 3 position.
3. Once the channel numbers on the weather station and sensor are the same.Proceed by opening the battery cover at the
back of your wireless sensor and insert 2XAAA new alkaline batteries to the battery compartment.Replace the battery
cover.
4. Press and hold the "CH" button for 3 seconds and your weather station will receive the data signal from the outdoor
transmitter in a few seconds.
5. Place your outdoor transmitters in a dry and shaded area once the weather station receives the data of this sensor.
Note：
If the weather station is used with 2 or 3 transmitters, press "CH" button shortly to display channel 1/2/3 or cyclic display.In
cyclic display,the channel will be changed every 5 seconds.
Deleting Sensors / clearing channels：
Press and hold the "CH" button for 3 seconds to clear the current channel to register.
Buttons：
MODE HISTORY
The DCF reception icon with full signal strength will appear on screen if the reception of atomic time is successful.

In normal display mode, press the "+" and "-" button at the same time to start the DCF searching.

The tower icon will stay solid when the station has received the DCF signal.

No tower icon displayed.The station was unable to receive a signal at this time.

Resposition the station for better signal reception and wait an overnight automatically receive hours：daily
1:00,2:00,3:00,4:00,5:00.DCF automatically receive,at any time once receive 3,4,5:00 no longer receive the same
day.

Only if unit receives summer time,it will display the "DST " icon.

If there is no signal or too much interference the receiver will only be on for 2 minutes.

If the signal is good it may catch a signal in about 2-3 minutes.

If the signal is weak it will try to catch a signal for up to 10 minutes.

In the normal display,hold the "+" and "-" button at the same time or hold the " CH" button to stop the DCF
searching.
+ - CITY
- AA +
+ AA
- AAA +
+
CH SNOOZE
EN 3
-
AAA -