MZ electronic MZBC_2460 Instructions D'utilisation page 17

MZBC model
Battery voltage (V)
Battery storage range (Ah)
Minimum cable size (mm²)
If only one battery pack is to be connected, the +B1, +B2 and +B3
outputs must be connected together. If one battery exit is not
used,connect it in parallel to another used
pole.
To view the operational status of the
battery charger, the voltage and the
distributed current, connect to the
battery charger an ENERGY001 remote
panel: press SEL to alternatively view the
battery tension – U- or the distributed
current – A –
CAUTION: the panel must be connected before switching on the battery
charger.
To carry out the connections use a flat cable and
the double RJ45 connector that is supplied along
with the remote panel. Insert one end of the cable
into the connector on the back of the panel and
the other end into the "PANEL" connector of the
battery charger. See picture on the right.
MZBC_2460
cable length up
to 5 m
17
English
2460
24
500-600
25
Rev. 02– 2015