MZ electronic MZBC_2460 Instructions D'utilisation page 16

Caution
THE APPLIANCE MAY GET DAMAGED IF THE
POLES OF THE BATTERIES ARE INVERTED.
The battery charger is equipped
with three separate outputs, +B1,
+B2 and +B3 each of which can
feed one battery. Connect the
positive pole of the first battery to
+B1, the positive pole of the second
one to +B2 and the positive pole of
the third one to +B3.
The negative poles of the three
batteries must be connected with
the terminal marked with the letters
NEG.
Select which type of battery is connected (lead or gel) via the special
LEAD/GEL deviator situated on the lower part of the battery charger
as shown in the picture:
The battery connection cables must have a section as indicated in
the table.
MZBC_2460
English
16
Rev. 02– 2015