Team kalorik TKG FT 1012 Mode D'emploi page 10

Fax +32 2 359 95 50

ASSEMBLY
See Illustrations
•
Place the appliance on a clean, flat and heat resistant surface.
•
Before using your appliance make sure:
The basket handle (7) is locked in place in the basket (6).
o
To lock the basket handle (7) in place, press the bars together and slide them
o
between the slots.
To insert the ends of the bars into the bracket on the basket (6) and push the
o
handle (7) backwards (ill. a and b). Do not assemble any other way (ill. c).
The oil reservoir (9) is secured in the correct position with the oil filter cover (11)
o
and oil valve (12) on the same side as the oil filtration control knob (14) (ill. d).
Ensure the oil filter cover (11) is in place inside the oil reservoir (9).
The control panel (21) is placed on the connecting plate on the back of the
o
housing (13). Ensure the grooves of the connecting plate are in the guides of the
control panel (ill. e).
NOTE:
➢
Your appliance is equipped with a safety switch (5) located on the control panel
(21). If the control panel (21) is not placed properly in its position, the appliance
will not operate.
•
Incorrect assembly may lead to an unstable setup and might cause injuries.
•
The silicon rubber sealing plate (22) prevents hot steam escaping from under the lid. Do
not attempt to remove it.
USING THE APPLIANCE
This appliance can be used for frying food such as French fries, chicken or fish (see
Recommended frying times and temperatures).
NOTE:
➢
The appliance has a rated power of 1700W. Before plugging it into the wall
outlet, ensure that the electrical circuit is not overloaded with other appliances.
This appliance should always be operated on a separate 230V ~ 60Hz wall outlet.
➢
Make sure the appliance is switched off before connecting it to a wall outlet.
•
Place the appliance on a clean, flat and heat-resistant surface. When using the
appliance on wooden surfaces, use a heat resistant mat to protect the wood from
damages. Ensure a minimum distance around the appliance of at least 4 inches to other
objects, cupboards and walls.
•
Ensure the oil container (15) is assembled, empty and in place inside the appliance, the oil
filtration control knob (14) is on the LOCK position and the oil filter cover (11) is in place
inside the oil reservoir (9). Then, pour suitable cooking oil into the oil reservoir (9) (ill. f).
Danger of burns!
➢
Never refill the oil reservoir (9) during use or while hot. Always allow the appliance
to cool down completely. Do not mix new and old oil.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you keep
the good numbering when you turn the pages of the I/B.
Don't change the page numbering. Keep the language
integrity.
10
Assembly page 10/72
TKG FT 1012
- 180912