Orbegozo DS 75 BL.N Serie Manuel D'instructions page 13

DS 75XXX BL.N / DS 80XXX BL.N
INSTALLATION
Preparation of installation
a. If you have an outlet to the outside, your cooker hood can be connected as below picture by means
of an extraction duct (enamel, aluminum, flexible pipe with and interior diameter of 150mm).
b. Before installation, turn off the cooker hood and unplug it from the outlet.
c. The cooker hood should be placed at a distance of 65-75cm above cooking surface for best effect.
Installation (outlet to outside)
- Drill 3x8mm holes to accommodate the bracket. Screw and tighten the bracket onto the wall with
the screws and screw plugs provided.
- Your model DS 75XXX/DS 80XXX needs to make 4x8mm holes more, place the hood in bracket, mark
the 4 points as the below picture shows, remove the hood and drill the holes. Place the screw plug.
13