Option 2, Shades In Programming Mode - Bandalux Roller Mode D'emploi

1. Installation procedure
A
1.1 OPTION TOTALLY PROGRAMMED SHADES
FOR THE FOLLOWING ORDERS
1 shade with 1 single
remote control
Power the motor (only for
C.C integrated motor).
B
1.2 OPTION SHADES IN PROGRAMMING MODE
FOR THE FOLLOWING ORDERS
Ordering multiple shades with multiple remote controls, where the association
of the remote controls is not specified.
Only connect the shade that we are going to program, never connect more than one shade to perform
this step of the manual.
Power the motor
(only for C.C
integrated motor)
GENERAL PROGRAMMING, RADIO BATTERY MOTORS AND C.C. INTEGRATED TRANSFORMER BANDALUX
Orders from more than 1 shade with more than
or
one remote control, where the remote control-
shade association is specified.
The motor already works with the
programmed ends of rail.
Press «Prog.» from
the motor head
(approx. 2 sec.).
or
The motor responds
x1 x1
Press simultaneously
«Roll up» and «Roll down»
from the remote control.
The motor responds
x1 x7
EN
45